Message Block Configuration Page (Message Blocks) - ABB SR100A User Manual

...6 CONFIGURATION – ADVANCED LEVEL

6.1.2 Message Block Configuration Page (Message Blocks)

Information.
• Fourteen 20-character message blocks.
• Message printing can be triggered by internal or external digital signals.
• Programmable color of message.
• Time stamping of all messages.
Message Blocks
MESSAGE BLOCK
CONFIGURATION
BLOCK TO CONFIGURE
OPERATOR MESSAGE
MESSAGE BLOCK
MESSAGE BLOCK
MESSAGE BLOCK
NONE
BLOCK MESSAGE
BLOCK SOURCE
BLOCK PEN
52
09:20 End Cleaning Cycle
09:00 Start Cleaning Cycle
Block to Configure (Operator Message or Message Block)
Select the message block to be configured.
Refer to Section 6.1.3 for Operator Message configuration.
14
ＡＢＢ记录纸记录笔打印头供应商：
广州绿图控仪器仪表有限公司
1
NONE
公司电话： ０２０－３４５１１９０９ １３０４２０８８１８１
公司传真： ０２０－３９０２１６１９
公司网站： ｗｗｗ．ｃｈａｒｔｇ．ｃｏｍ
Ｅ － ｍａｉｌ ：ｃｈａｒｔ＠ｃｈａｒｔｇ．ｃｏｍ
6789:;<=>?@ABCDEF
Block Source
Select the required source to activate the printing of the message block.
TOTAL WRAP
PAPER OUT ALARM
I/P FAILURE
DIGITAL I/P
CHART SPEED
LOGIC EQN
POWER FAILURE
REAL TIME ALM
PROCESS ALARM
NONE
Block Pen
Select the pen required to print the message block (refer to Table 5.5 on page 43
for pen options).
Return to
Block to Configure
Trace
Block Message
Set the required message required on the
upper display – see Front Fold-out.
– Wrap-around of a totalizer (T1 to T6)
– End of chart reached
– Failure of analog input (A1 to A6, B1 to B6)
– Active digital input (DA1 to DG3)
– Selection of chart speed (1 to 3)
– Logic equation true (1 to 10)
– After power failure
– Real time alarm on (1 or 2)
– Pre-defined process alarm (A to M, excluding I)
– No output source required
frame.