Table of Contents
Advertisement
5
Initial start-up
5.1
Information on initial operation
WARNING
Inhaling poisonous gases in the enclosed
rooms
Danger of poisoning and suffocation
Never operate the heater (also not with program-
X
X
med heating start) in closed rooms such as ga-
rages or workshops that do not have an exhaust
extraction unit.
In workshops with exhaust extraction facilities,
X
X
make sure that the exhaust extractor is fully
operational.
WARNING
Hazardous substance transportation (ADR):
programmed heating start not permitted
Select and confirm ADR function in the menu.
X
X
See „6.3 Select ADR function" on page 7.
Observe additional provisions for the installation
X
X
of the control element in vehicles for hazardous
substances.
3
Heater is correctly installed.
3
Control element is correctly installed.
3
Vehicle on-board power supply is connected to the battery
voltage.
Select heater
Is omitted if the heater is automatically detected
Rotate the control knob and select the installed heater.
Fig. 04: "Heater" menu element
Press the control knob.
X
X
Setting the day of the week:
Fig. 05: Day of the week
Rotate the control knob, select weekday.
X
X
UniControl
www.butlertechnik.com
Mon
www.butlertechnik.com
Fig. 06: Setting the time
Setting the time:
Rotate the control knob, set the hour.
X
X
Press the control knob.
X
X
Rotate the control knob, set the minutes.
X
X
Press the control knob.
X
X
Fig. 07: Main menu
When the main menu is displayed, initial start-up is completed.
The selected heater can be changed at a later date
using the Service menu. See „6.2 Manual heater
selection" on page 7.
Heating
6
Advertisement
Table of Contents
