Table of Contents
Advertisement
4
Installing the control
element
4.1
Notes on installation
CAUTION
Danger of fire due to drilling into electrical
cables
Burn injuries
Arrange electrical cables behind the installation
X
X
area outside the drilling points.
CAUTION
Injuries by touching sharp edges
Grazing of the skin, cuts
When installing use
X
X
protective gloves.
4.2
Installation location requirements:
Comply with legal requirements.
The installation location must satisfy the following requirements:
3
Vehicle interior
3
Ease of access
3
Clear visibility
3
Clean, dry and free of grease
3
Protected from moisture
3
Protected from heat, not in direct hot air flow
3
Sufficient clearance behind installation location
4.3
Installing the control element
Installation
1
Fig. 02: Installing the control element
1
Installation location
2
Optional: installation frame
3
Control Element
Determine the installation location.
X
X
Cut out the installation opening.
X
X
UniControl
www.butlertechnik.com
X
X
X
X
Fig. 03: Example of connecting control element (1) to heater (2)
2
3
www.butlertechnik.com
Locate bushing for control element wiring harness.
X
Rotate control element wiring harness through installation
X
opening.
Attach connector.
X
Carefully latch control element into position.
X
2
1
5
Advertisement
Table of Contents
