Instant Pot PRO PLUS User Manual page 49

Troubleshooting
Problem
No sealing ring in the lid.
The sealing ring is damaged or
not installed properly.
Food debris on the
sealing ring.
Steam leaks
from the side
The lid is not closed properly.
of the lid.
The sealing ring rack is warped
or off-center.
The cooking pot rim may be
misshapen.
Food debris on the float valve
or float valve silicone cap.
Too little liquid in the cooking
pot.
Float valve silicone cap
Cooker can't
damaged or missing.
build pressure.
Float valve obstructed by lid-
locking mechanism.
No heat in the cooking pot.
Cooking pot base may be
damaged.
Minor steam
leaking or
hissing from
The multicooker is regulating
the steam
excess pressure.
release
valve during
Cooking.
Steam gushes Not enough liquid in the
from the steam cooking pot.
release valve
during pressure
Pressure sensor control failure.
cooking cycle.
Possible reason
Install a sealing ring.
Replace the sealing ring.
Remove the sealing ring and clean it thoroughly.
Open, then close the lid.
Remove the sealing ring from the lid, then check the
sealing ring rack for bends or warps. Contact Customer
Care.
Check for deformation and contact Customer Care.
Run clear water through float valve in the lid. Perform
the Initial test run to check for function and record
your findings. Contact Customer Care.
Check for scorching on the bottom of the cooking pot.
Add thin, water-based liquid to the cooking pot according
to its size.
Contact Customer Care.
Contact Customer Care.
Perform the Initial test run to check for function and
record your findings. Contact Customer Care.
Perform the Initial test run to check for function and record
your findings. Contact Customer Care.
This is normal; no action required.
Add thin, water-based liquid to the cooking pot according
to its size.
Contact Customer Care.
Try this
instantbrands.co.uk | 49