Analysis Cycle; Programming Commands; Table 2.1: The Run Sequence Of Colorimetric Determination - Waltron 3048 User Manual

ANALYSIS CYCLE

2.4

PROGRAMMING COMMANDS

2.4.1
An analysis time program in the Waltron 3048 Dissolved Iron Analyzer has the following
structure:
1. After rinsing the reaction colorimetric cell and taking a sample, a reference measurement
is taken. In this way interfering factors are eliminated such as sample color or turbidity,
reagent color, or refractive index variations.
2. The actual Dissolved Iron reading is taken after addition of the color forming reagent and
color development.

Table 2.1: The run sequence of colorimetric determination.

Conditioning, rinsing and sampling
Drain, rinse and sample functions
Mixing and wait
Mix and wait functions
First measurement
Reference function
Addition of color reagent(s)
Add reag function
Mixing and wait
Mix and wait functions
Reading, absorbance and
concentration calculation
Read sensor, absorbance, calculation
Drain, conditioning, rinsing, sampling
Drain, rinse and sample functions
Waiting time (analysis frequency)
Wait function
Waltron User Manual 101-024-B.1
3048 Dissolved Iron Analyzer
The colorimeter cell is drained and refilled with sample 3
times, and then filled and left full of sample. This clears the
sampling pump, tubing, and cell and insures a fresh sample
is analyzed.
The waiting time is programmed in order to eliminate
bubbles and suspensions.
A reading is taken using the colorimeter to provide a
reference value to compare the measured color against. This
automatically corrects for sample background color or
turbidity.
Reagent 1 is added to form the color.
The mixing pump is activated and the liquid is pumped from
the lower part to the upper part of the colorimetric cell; in
this way reagent(s) is mixed. The waiting time is
programmed in order to complete the colorimetric reaction.
Reading of the light intensity after the colorimetric reaction,
calculation of the absorbance and of the concentration.
Drain and rinse of the hydraulic line and the colorimetric
cell.
The wait function is a programmable time the user can use
to determine sample and analysis frequency.
Introduction
18