olympia electronics GRL-22 Quick Start Manual

GRL-22
``POWER LIGHT`` SERIES NON-MAINTAINED EMERGENCY LUMINAIRE
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Pb)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
LIGHT SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Thank you for your trust in our products
Olympia Electronics - European manufacturer
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed. Each
luminaire must be permanently connected to
mains power supply. In normal operation the
power and charge indicators are on to indicate
that the batteries are charging. In case of a
mains power supply failure the power and
the charge indicators turns off and the
l u m i n a i r e w i l l l i g h t t h e s p o t l a m p s
automatically in emergency mode. When the
mains power supply is restored the device
turns to normal operation.
INSTALLATION
To install the luminaire follow the installation
instructions οn page 3.
OPERATION
When the device is powered from the mains
and the battery(ies) is (are) connected, the
'power' and 'charge' indicators are ON. The
'charge' indicator indicates the battery charging
operation. If it does not light, probably, the
batteries are disconnected. If it does not light
and the batteries are connected, then contact
the technician. The power indicator confirms
the proper connection to the mains. The TEST
button, has a dual use. If pressed instantlly
while the device is connected to the mains, the
Page 1 from 3
(for LED MODULE Specs. see page 2)
220-240V AC/50-60Hz
16VA
12V/7Ah
From overcharge and deep discharge
Power indicator, battery charge indicator, TEST button
<24h
600 min
White LEDs
710lm
IP42
o
5 to 40 C
Up to 95%
ABS/PC, PC
302 x 103 x 230 mm
3400gr.
3 years (1 year for the battery)
device simulates the power interruption, by
lighting the lamps for 3''. In that way, we can
o
control the driver circuit of the lamps and the
lamps as indicated in paragraph 3 in the text
below.
DIMMING OPTION
When the luminaire is in emergency mode, with
corresponding pressings of the button, we can
choose the illumination of 100%, 50%, 33% or
turned off, in order to increase the autonomy
duration. This option is canceled when the
network is restored.
923022100_09_007