Configure The Device - Crestron Control System 3 Series Quick Start Manual

CP3 and CP3N
3-Series Control System® Automated Processors

Configure the Device

The control system can be configured using Crestron Toolbox™ software
and the included web-based configuration utility.
To configure the control system:
1. Use the Device Discovery tool in Crestron Toolbox to discover the
control system and its IP address on the network.
2. Use Crestron Toolbox to set the time zone. For more information refer
to the Crestron Toolbox help file.
3. Use a web browser to navigate to http://xxx.xxx.xxx.xxx/setup, where
xxx.xxx.xxx.xxx is the IP address of the control system. The 3-Series
splash page is displayed.
4. Click Setup. The main Setup page is displayed.
The Setup page displays the IP address, hostname, and MAC address of
the control system, as well as a key that is used to register the control
system with the MyCrestron service.
The Setup page also provides access to various setup and programming
pages.
Click one of the setup selections to configure the applicable device
l
settings.
Click the back button on any page to return to the previous page.
l
Quick Start
5