Table of Contents
Advertisement
b. Using a 10mm drill bit, drill four holes in the marked locations and push the
Wall Plugs inside.
c. Position the Brackets over the holes and fix in place using the Washers and
Wall Screws. The Brackets should slot between the bars with their mounting
plates facing together: with the Left Brackets on the left and the Right
Brackets on the right as you face the radiator (see Figure 5). Make sure that
the Upper Brackets (with the Safety Hook attached) are at the top of the
radiator, and the Lower Brackets are at the bottom.
Figure 5 | Fixing the wall brackets
5. If you require your Left and Right Brackets to be spaced
closer together or farther apart, for example when
affixing to studs in a stud wall, you can choose custom
Bracket positions.
a. Choose the point where the Brackets will sit
between the radiator bars, according to your
requirements.
b. The Brackets should slot between the bars with
their mounting plates facing together: with the
Left Brackets on the left and the Right Brackets
on the right as you face the radiator. Make sure
that the Upper Brackets (with the Safety Hook
attached) are at the top of the radiator, and the
Lower Brackets are at the bottom.
c. Use a tape measure, spirit level and the positions
decided in step a above to mark the Bracket
positions on the wall (see Figure 6).
Ecostrad_Allora_V_V1.1.4_12102022
Figure 6 | Fixing without template
8
Advertisement
Table of Contents
