RUGGEDCOM RSG2300F
Installation Guide
Device Management
This section describes how to connect to and manage the device.
CONTENTS
•
Section 3.1, "Connecting to the Device"
•
Section 3.2, "Configuring the Device"
Section 3.1
Connecting to the Device
The following describes the various methods for accessing the ROS-F console and Web interfaces on the device.
For more detailed instructions, refer to the RUGGEDCOM ROS-F User Guide for the RUGGEDCOM RSG2300F.
RS232 Console Port
Connect a workstation directly to the RS232 console port to access the boot-time control and ROS-F interfaces.
The console port provides access to ROS-F's console and Web interfaces.
IMPORTANT!
The serial console port is intended to be used only as a temporary connection during initial
configuration or troubleshooting.
Connection to the console port is made using an RJ45-to-DB9 console cable. The following is the pin-out for the
console port:
8
Figure 13: RJ45 Console Port Pin Configuration
Connecting to the Device
1
RJ45
Male
1
2
3
4
5
6
7
Pin
Name
Description
DB9
Female
a
6
DSR
Data Set Ready
a
1
DCD
Carrier Detect
a
4
DTR
Data Terminal
Ready
5
GND
Signal Ground
2
RxD
Receive Data
(to DTE)
3
TxD
Transmit Data
(from DTE)
b
8
CTS
Clear to Send
Chapter 3
Device Management
Comment
Reserved (Do
Not Connect)
19