Cisco WIP310 User Manual page 12

Getting to Know Your WIP310
Charging the Phone
STEP 1
STEP 2
STEP 3
!
CAUTION
NOTE
Cisco WIP310 User Guide
To charge the phone:
Place the phone in the charging cradle.
Connect one end of the power supply to the phone charger.
Connect the other end of the power supply to an electrical outlet.
See Charging the Battery, page
You can also connect one end the included USB cable to the USB port on the
bottom of the phone and the other end to your PC to charge the phone.
Figure 1 USB port on phone
The battery must charge for at least 8 hours prior to the phone's initial use. Do not
power on the phone for the first time until it has charged for at least 8 hours.
Talk time for the phone is approximately three (3) hours and standby time is
approximately 40 hours.
Talk and standby time can vary widely depending on your phone settings and
wireless environment. Cisco recommends that you keep the phone in the charger
when it is not in use.
22.
1
11