treesse ATC System Instructions For Use Manual page 11

_RADIO REMOTE CONTROL - HOW TO USE
Blowing
The blowing after function (elimination of residual water from the pipes of the airpool) is enabled
After
only after the level sensor has detected the presence of water in the tub for at least 2 minutes.
Will be activated automatically after the level sensor (5 cm over the nozzle) has not detected
water for at least 12 minutes. Consists of the following steps:
• turn on the blower at minimum speed
• bring the blower at full speed with a 15 second ramp
• maintain maximum speed for 75 seconds
• disable the blower
During the blowing after, the button P3 has dimmed white backlight. You can stop blowing
after using the P3 button for more than 1 second. Once activated, the function is completed
even if water is detected.
Key P5:
By pressing P5 you will start the colour therapy cycle in which the colours change automatically
at regular intervals, or a monochrome spotlight turns on (depending on the tub). The key backlight
of key P5 switches from dimmed white to intense white and automatically turns on the P6 key
(see the specifications
The colour range consists of 8 colours (from white to purple), which light up cyclically. A complete
cycle lasts 2 minutes, 15 seconds for each colour.
To switch the function off, press and hold the buttonP5 again, or it will turn off automatically
after 30 minutes.
The key P6 can be used only after activating the key P5. This button allows you to change the
Key P6:
colour by hand; it turns on even in the absence of colour-therapy, but it will not work in this case.
By pressing the key P6 you will lock the automatic colour therapy cycle, switching to colour
change in manual mode and the icon switches from blinking to fixed; subsequent pushes allow
you to choose one colour at a time, within the same range as that described for the key P5.
To disable this function, press the key P5, turning off the lights.
Keys P7,
Not covered in this manual.
P8 - P8 :
a b
Key P9:
It allows you to adjust the volume of any sound system, not covered in this manual.
The icon is also used to report:
_ The state of battery charge in a proportional logic, according to the following criteria:
1 dash low charge/4 dashes fully charged. You can view it upon exiting from STAND-BY mode
for about 3 seconds.
_ The status of receiver signal search, with dashes blinking blue.
11
below).