Advertisement
F10
Troubleshooting
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
24
Downloaded from
Elcodis.com
electronic components distributor
Problem
Head disconnection error
8
The Head is not connected properly and no
7
image signal is obtainable.
6
5
4
3
This LED of the threshold
indicators flashes and the
2
buzzer sounds.
1
Hardware error
8
A hardware failure, such as CPU runaway,
7
has resulted.
6
5
4
This LED of the threshold
3
indicators flashes and the
buzzer sounds.
2
1
Head data read error
8
1.The EEPROM data of the Head is not
7
6
5
This LED of the threshold
2.The data is illegal.
indicators flashes and the
4
buzzer sounds.
3
2
1
Amplifier data read error
8
1.The EEPROM data of the Amplifier is not
7
6
5
2.The data is illegal.
This LED of the threshold
4
indicators flashes and the
3
buzzer sounds.
2
1
Amplifier data write error
8
1.No EEPROM data is written to the
7
6
This LED of the threshold
5
indicators flashes and the
2.The data is illegal.
buzzer sounds.
4
3
2
1
Head type error
8
An F10-S30/S15 is connected to the head.
7
This LED of the threshold
6
indicators flashes and the
buzzer sounds.
5
4
3
2
1
Teaching data setting error
8
The Sensor was set to MONITOR or RUN
7
All the LEDs of the
mode before teaching completed.
6
threshold indicators flash
and the buzzer sounds
5
three times.
4
3
2
1
Probable cause
readable.
readable.
Amplifier.
Remedy
Connect the Head and turn the Sensor
OFF and ON.
Note:
If the same error occurs again, the
Head may be broken. Consult your
OMRON representative.
Consult your OMRON representative.
Turn the Sensor OFF and ON.
Note:
All internal data of the Amplifier may
be cleared.
Note:
If the same error occurs again after
turning the Sensor OFF and ON,
consult your OMRON representa-
tive.
Connect an F10-S30R/S15R/S05R to the
head.
Perform the teaching of the Sensor in
TEACH mode.
Refer to 1. Pattern Registration
(TEACH Mode) on page 19.
F10
Advertisement
