Advertisement
CANDY CLAW MACHINE ASSEMBLY
asseMbly vIdeo!
Scan this QR code to view a
step-by-step assembly video
and for more tips on building and
using your Candy Claw Machine.
2
A1
3
Back side
Note: There is a small tab on the bottom of P1. When
the spools (A9) are on the left side of the tab, they can
not rotate relative to the driveshaft (A1).
Later, when installing the ribbon (step 43), the spool
on the inside moves to the other side of the tab so that
it can spin freely without rotating the drive shaft.
4
Assembling the Candy Claw Machine
P1
P2
1
P3
P3
Note: If the suction cups get
stuck to your work surface
during assembly, you can
remove them from the model
until the end.
P14 x3
A8
A9 x2
3 3
Advertisement
