Advertisement
Attach the handles (C1) to hydraulic cylinders H1 and H2 using the clips (C13).
Then, attach the pegs as show below. H1 is on the right; H2 is on the left.
C1
C1
C13
C1
25
Guide the tubes up through the holes in the
base (1) and top (2) of the machine.
Once the first tube is
already passing
through the holes, it is
harder to pass the
second tube
connector (C12)
through the holes. You
just have to wiggle it
and push it through. It
will fit.
26
A7
27
8
H2
H1
C12
2
1
C13
C13
For each cylinder, snap the left peg into
the base first. Then snap in the right peg.
Guide the tubes back, under the base.
2
1
1
2
A7
Advertisement
