Table of Contents
Advertisement
OPERATION OF REMOTE CONTROLLER (Continued)
Under COOL or HEAT mode, press this button to turn to
quick COOL or quick HEAT mode. " " icon is displayed
on remote controller. Press this button again to exit
turbo function and " " icon will disappear. This function
will allow the unit to run at very high fan speed to reach
the desired temperature.
• Press " " or " " button to increase or decrease the
set temperature 1 °C(2°F). Hold " " or " " button for 2
Sec, set temperature on remote controller will change
quickly. Temperature indicator on indoor unit will
change accordingly.
• When setting T-ON, T-OFF or CLOCK, press " " or " "
button to adjust time. (Refer to CLOCK, T-ON, T-OFF
buttons)
Press this button to select left & right swing angle.
Fan blowing angle can be selected circularly as below:
NOTE
• Press this button continuously more than 2s, the
louver will swing back and forth from left to right,
when you release the button, the louver will stop
swinging at its present position.
• Under left and right swing mode, when the status
is switched from off to
again for 2s and
status will switch to off status;
pressing this button again for 2s, will change the
swing status according to the sequence shown
above.
• This function is not available for this unit
Press this button to select up & down swing angle. Fan
angle can be selected circularly as below:
S L IM DUC T B S E R I ES OW N E RS M A N UA L - I N D OOR U N I T
, pressing this button
• Select " ", to select automatic fan circulation.
Horizontal louver will automatically swing up & down
at maximum angle.
• Select "
", and fan modulation will stop at
that fixed position. Horizontal louver will stop at the
fixed position.
• Select "
", will not modulate but blow at a fixed
angle.
• Hold " " button more than 2s to set your required
swing angle. When reaching your desired angle,
release the button.
NOTE
• Pressing this button continuously for more than
2s, the louver will swing back and forth from up to
down, release the button, will stop the louver at the
desired position.
• Under up and down swing mode, when the status is
switched from off to
for more than 2s will turn off the
again within 2s, will change the swing status to the
diagram above.
• This function is not available for this unit
• T-ON button
"T-ON" button will set the time for timer on. After
pressing this button, " " icon disappears and the
word "ON" on remote controller blinks. Press
" " or " " button to adjust T-ON setting. After each
pressing " " or " " button, T-ON setting will increase
or decrease 1min. Hold " " or " " button, 2s longer
and the time will change quickly until reaching your
desired time. Press "T-ON" to confirm. The word
"ON" will stop blinking. " " icon resumes displaying.
Cancel T-ON: If T-ON is initiated, press "T-ON" button
to cancel it.
• T-OFF button
"T-OFF" button will set the time for timer off. After
pressing this button, " " icon disappears and the
word "OFF" on remote controller blinks. Press " " or
" " button to adjust T-OFF setting. After each press
of the " " or " " button, T-OFF setting will increase or
decrease 1 min. Holding the " " or " " button for more
than 2s the time will change quickly until reaching
your desired time. Press "T-OFF" and "OFF" will
stop blinking. " " icon resumes displaying. To cancel
T-OFF when it's on, "T-OFF" button to cancel it.
| 1 8
. Pressing this button again
status. Pressing
Advertisement
Table of Contents
