Table of Contents
Advertisement
Wired Controller (Continued)
2 Buttons
2.1 Buttons on the Wired Controller
No.
Display
Instruction of Display
1
SWING/ENTER
1
2
3
1
7
2
Setting of the auto/ low/ medium low/ medium/ medium high/ high fan speed.Heating mode
6
FAN
Setting of the Cooling/ Heating/ Fan/ Dry/ Auto mode of the indoor unit.
4
MODE
Switchover among the functions of Turbo/ WiFi/ X-fan etc..
5
FUNCTION
2
TIMER
Timer setting.
Turn on/off the indoor unit.
8
ON/OFF
Press them for 5s under off state of the unit to Enter/ Cancel the Memory function (If memory is set, indoor unit after power
3+4
+ MODE
failure and then power recovery will resume the original setting state. If not, the indoor unit is defaulted to be off after power
recovery. (Memory off is the factory default setting)
By pressing them at the same time under off state of the unit,
6+7
FAN +
unit, while
Upon startup of the unit without malfunction or under off state of the unit, press them at the same time for 5s to enter the lock
3+7
+
state, in which case, any other buttons won't respond.
Repress them for 5s to quit this state. Under OFF state, the Celsius and Fahrenheit scales can be switched by pressing "MODE"
4+7
MODE +
and " " for 5s.
2+5
TIMER+FUNCTION
Under OFF state, go to the commissioning status by pressing "FUNCTION" and "TIMER" for five seconds, and let "00" displayed
on he temperature display area by pressing "MODE", then adjust the options which is shown on the timer area by pressing " "
and " ". There are four options, as follows:
1
2
3
sensor is selected under the heating or auto mode. (03 is displayed on the timer area).
4
sensor is selected under the heating mode. (04 is displayed on the timer display area).
Under OFF state, go to the commissioning status by pressing "FUNCTION" and "TIMER" for five seconds. Press "MODE" button to
2+5
TIMER+FUNCTION
until "01" icon is shown at the temperature display area. The setting status will be show–––tn at timer area. Press " " and " "
button to adjust and two options are available:
5+6
FUNCTION + FAN
Reset the WiFi function: Under off status, press "FUNCTION" + "FAN" combination buttons on its wired controller for 5s. Once
"oC" is displayed, this indicates that reset was successful.
S L IM DUC T B S E R I ES OW N E RS M A N UA L - I N D OOR U N I T
1
5
Fig. 3 Buttons on the Wired Controller
Function selection and cancellation.
Setting of the up and down swing function.
Running temperature setting of the indoor unit, range:61~86°F(16~30
Timer setting, range:0.5-24 hr.
will be displayed on the wired controller for the cooling and heating unit.
Indoor ambient temperature is sensed by the return air temperature sensor (01 displayed on the timer area).
Indoor ambient temperature is sensed by the wired controller (02 displayed on the timer area).
The return air temperature sensor is selected under the cooling, dry, or fan mode; while the wired controller temperature
The wired controller temperature sensor is selected under the cooling, dry, or fan mode; while the return air temperature
2
3
4
6
7
8
2
C).
0
will be displayed on the wired controller for the cooling only
Three low levels (01) ;
Three high levels (02).
1
2
| 1 0
Advertisement
Table of Contents
