Torque Settings - ADJ HYDRO BEAM X1 User Manual

T O R Q U E S E T T I N G S
ALL SCREWS MUST BE TIGHTENED WITH A TORQUE DRIVER. All screws are Allen Head
screws. Please refer to the illustration and table below for screw locations, screw quantity, and torque
settings. The number listed in the "#" column corresponds to the location on the fixture.
1 Lens Assembly to Head Casting (x14)
2 Lamp Cover to Head Casting (x4)
3 Plastic Head Cover to Head Casting (4 x each side = 8 total) 6.5 - 8.7 In-Lb / 3mm Hex
4 Yoke Arm Cover to Yoke Frame (11 x each side = 22 total)
5 Access Cover to Yoke Frame (x4)
6 Bottom Cover to Base Casting (x16)
7 Power and Data Connector to Base Casting (x8)
8 1/4 Turn Adapter Plate to Bottom Cover (x16)
1
4
3
5
16
2
7
6
6
8
8
6
6.5 - 8.7 In-Lb / 3mm Hex
6.7 - 9.6 In-Lb / 4mm Hex
6.5 - 8.7 In-Lb / 3mm Hex
Manual Screwdriver / 3mm Hex
6.7 - 9.6 In-Lb / 3mm Hex
6.5 - 8.7 In-Lb / Torx T8
6.5 - 8.7 In-Lb / 3mm Hex
6