Torque Settings For Screws - ADJ JOLT BAR FXIP User Manual

T O R Q U E S E T T I N G S F O R S C R E W S
ALL SCREWS MUST BE TIGHTENED WITH A TORQUE DRIVER. All screws are Allen Head screws.
Please see below for screw locations.
Fixed Bracket Assembly
(10±0.5/Kgf.cm)
Fixed Base Cover Plate
(10±0.5/Kgf.cm)
TORQUE DRIVERS
(Recommended): UTICA TS-30
ALTERNATIVE DRIVERS:
Proto J6107A
Wiha 28887
CAUTION! DO NOT OVER TORQUE SCREWS AS THIS CAN CAUSE LEAKAGE
ISSUES! TO CONFIRM THE IP65 INTEGRITY AFTER MAINTENANCE, TEST THE
FIXTURE USING THE ADJ IP TESTER. CONTACT ADJ SERVICE FOR MORE DETAILS.
Vacuum(KPA)
-50KPA
IF IN THE UNLIKELY EVENT THAT A
PRESSURIZED FIXTURE
CATASTROPHIC LENS
PROTECTION MUST BE WORN AT ALL
TIMES WHEN USING ADJ IP TESTER,
ESPECIALLY WITH FIXTURES FEATURING
LARGE GLASS LENSES. ALSO, TO PROTECT
HANDS FROM ANY SHARP FRANGIBLE
MATERIAL, THE USE OF CUT RESISTENT
GLOVES IS ALSO HIGHLY RECOMMENDED.
fixed pressure strip
(13±0.5/Kgf.cm)
Encore Burst UV IP Testing Parameters
Hold time(S)
60S
RESULTS IN
FAILURE, EYE
Fixed Back Cover
(13±0.5/Kgf.cm)
Pressure(KPA)
13KPA
10
fixed connection plate
(10±0.5/Kgf.cm)
Fixed Side Cover
(13±0.5/Kgf.cm)
Hold time(S)
60S