Description Of Function; Safety Regulations And Appropriate Application - Carbest 851005 User Instructions

Mppt solar charge controller 12a/25a
Hide thumbs Also See for 851005:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
UK

DESCRIPTION OF FUNCTION

Increased MPP charging current compared with conventional controllers, due to
ultramodern controller technology (microprocessor) by 10 % to 30 % (efficiency > 95 %).
Switchable characteristic lines of charging for optimum charging of Gel/dryfit/AGM/fleece or
acid/lead-acid, as well as LiFePO4 batteries.
Two Battery Charging Ports: Automatic charging of the main battery or board battery (Board I):
Support charging and trickle charging (max. 1 A) of the vehicle's starter battery (Start II) with
overcharge protection.
Unattended Charging: Standard protection against overload, overheating, reverse battery and back
discharge of the battery (in case of insufficient solar power, such as at twilight, at night etc.).
Overcharge protection: Reduction of the charging current of the battery in case of excessive solar
power and full battery. Immediate recharging in case of power
consumption to ensure always the best possible charging state of the battery.
Connection for temperature sensor: Automatic adaptation of the charging voltage to the battery
temperature. In case of low outside temperatures, full charging of the weaker battery is improved,
and in case of summery temperatures unnecessary battery gassing will be avoided.
This is highly recommended, if the battery is exposed to strong variations in temperature,
such as in the motor compartment.

SAFETY REGULATIONS AND APPROPRIATE APPLICATION

Charging of lead-gel, lead-AGM, lead-acid or LiFePO4 (with integrated BMS!) batteries of the indica-
ted nominal voltage and simultaneous supply of the consumers being connected to these batteries
in fixed installed systems.
Solar panels up to the maximum power rating (Wp) of the used solar controller.
The indicated cable cross sections at the charging ports and at the panel input.
With fuses of the indicated capacity near the battery to protect the cabling between battery and
charging ports.
Installation in a well-ventilated room, protected from rain, humidity, dust, aggressive battery gas,
as well as in an environment being free from condensation water.
Except for the fuse, the unit is not equipped with parts, which can be replaced by the user. Always
use replacement car fuses of the indicated capacity!
Keep children away from the solar controller and the batteries.
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

851006

Table of Contents