STIEBEL ELTRON PEG 13 Operation And Installation Manual page 7

iNSTallaTiON
installation
f Drill the holes and secure the wall mounting bracket with
2 screws and 2 rawl plugs (screws and rawl plugs are not
part of the standard delivery).
f Fit the threaded stud provided.
f Fit the wall mounting bracket.
Fitting the cable grommet
f Fit the cable grommet. For connecting cables > 6 mm², en-
large the hole in the cable grommet.
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors.
Material losses
!
Never use the shut-off valve in the cold water inlet to
reduce the flow rate.
www.stiebel-eltron.com
Preparing the back panel
Material losses
!
If you break open the wrong knock-out in the back panel
by mistake, you must use a new back panel.
f Break out the cable grommet knock-out in the back panel.
Deburr any sharp edges with a file if necessary.
Installing the appliance
3
L3'
4
L2'
1
L1'
2
f Push the back panel over the threaded stud and the cable
grommet. Pull the cable grommet by the locking hooks into
the back panel using pliers, until both locking hooks audibly
click into place.
f Remove the protective transport plugs from the water
connections.
f Press the back panel firmly into place and lock the fixing tog-
gle by turning it clockwise through 90°.
PEG | 7