Connection The Condensation Drainage Hose; Connection The Condensation Discharge Hose To The Interior Unit - Qlima S 7026 Operating Manual

Outer
diam.
Ø 6.35
Ø 9.53
Ø 12.7
Ø 16.0
e. Insulate the connection points on the interior section with insulation material to prevent condensa-
tion build-up .
f. Wind the piping, connection cable and drain hose, behind the interior unit, with tape so that a firm
bundle is formed. This makes it easier to mount the interior unit to the mounting plate.
Indoor unit
Connective cable
Drain hose
G
ATTENTION
Copper lines must be insulated independently from each other.
G
ATTENTION
Always use the highest care when bending the piping. Make sure that the piping always is
bent and not buckled. In case of a buckled pipe: replace the complete piping or the buckled part,
as this is a potential refrigerant leak and may cause damage to the air conditioner.
9.

CONNECTION THE CONDENSATION DRAINAGE HOSE

9.1

Connection the condensation discharge hose to the interior unit.

Connect the included condensation drainage hose to the interior unit by sliding the hose over the hose nip-
ple on the interior unit. Ensure that the condensation drainage hose always runs downwards and do not
hang the end in the water. See fig. 12.
Always run the condensation drainage hose under the coolant pipes to prevent that the condensation tray
from overflowing.
CAUTION
• Be sure that the drain hose is located at the lowest side of the bundle. Locating at the upper
side can cause drain pan to overflow inside the unit.
• Run the drain hose sloped downward over the whole length to drain out the condensed water
smoothly.
Instal_S70xx ('21) V1.indd 29 Instal_S70xx ('21) V1.indd 29
Tightening torque Additional tightening
(N.cm) torque (N.cm)
1500
(153kgf.cm) (163kgf.cm)
2500
(255kgf.cm) (265kgf.cm)
3500
(357kgf.cm). (367kgf.cm)
4500
(459kgf.cm). (479kgf.cm)
Ponding box
Pipe room
Connective pipe
Wrapping belt
Figure 11
1600
2600
3600
4700
4
29 29
08-11-2021 18:12 08-11-2021 18:12