Connect Drain Hose - Qlima S65 Series Operating Manual

G
ole
Step 5: Connect drain hose
By default, the drain hose is attached to the left hand side of unit (when you're facing the back of the
unit). However, it can also be attached to the right-hand side. To ensure proper drainage, attach the drain
hose on the same side that your refrigerant piping exits the unit. Attach drain hose extension (purchased
seperately) tot the end of the drain hose.
•
•
•
G
NOTE ON DRAIN HOSE PLACEMENT
Make sure to arrange the drain hose according to the following figures.
CORRECT
Make sure there are no
kinks ordent in drain hose to
ensure proper drainage.
NOT CORRECT
Kinks in the drain hose will
create water traps.
man_S60xx SCAN ('21) V4.indd 115 man_S60xx SCAN ('21) V4.indd 115
NOTE ON PIPING ANGLE
Refrigerant piping can exit the indoor unit from Left-rear side(when you're facing the back of the
unit)
CAUTION
Be extremely careful not to dent or damage the piping while bending them away from the unit.
Any dents in the piping will affect the unit's performance.
Wrap the connection point firmly with Teflon tape to ensure a good seal and to prevent leaks.
For the portion of the drain hose that will remain indoors, wrap it with foam pipe insulation to
prevent condensation.
Remove the air filter and pour a small amount of water into the drain pan to make sure
that water flows from the unit smoothly.
Kinks in the drain hose will
create water traps.
NOT CORRECT
Do not place the end of the
drain hose in water or in
containers that collect water. This
will prevent proper drainage.
NOT CORRECT
4
115
09-11-2021 09:07 09-11-2021 09:07