Unit Parts; Activities For Installing The Air Conditioner - Qlima S 7026 Operating Manual

3.

UNIT PARTS

1. Wall Mounting Plate
2. Front panel
3. Power Cable (some units)
4. Louver
G
ATTENTION
This illustration is for explanation and indication purposes only. The illustration may be different
from the air conditioner you purchased.
4.

ACTIVITIES FOR INSTALLING THE AIR CONDITIONER

a. Determine the location where the interior unit and exterior unit can be installed. See chapter 5 and 6.
b. Mount the mounting plate of the interior unit. See chapter 7.1.
c. Drill a hole to outside that the lines can be fed through. See chapter 7.2.
d. Hang the interior unit, by the hooks on the back, on the top hooks of the mounting plate and check
that it is securely mounted. Do not click the bottom hooks in yet.
G
CAUTION
if the piping is exiting the unit behind on the right then the piping must be fed through the
drilled hole at the same time as hanging the interior unit.
e. Feed the piping, the power cable and the condensation hose through the hole in the wall.
4
22 22
Instal_S70xx ('21) V1.indd 22 Instal_S70xx ('21) V1.indd 22
Figure 1
5. Functional Filter (On Back
of Main Filter - Some Units)
6. Drainage Pipe
7. Signal Cable
8. Refrigerant Piping
9. Remote Controller
10. Remote controller Holder
(Some Units)
11. Outdoor Unit Power Cable
(Some Units)
08-11-2021 18:12 08-11-2021 18:12