Functions; Commissioning - MDT SCN-RT1UP.01 Technical Manual

Technical Manual
Room Temperature Controller

2.5 Functions

The controller has 5 different setting ranges, which are subdivided as follows:
•
Setup general
General settings can be made at this menu and the used device can be chosen.
•
Temperature measurement
The settings for the measurement for the temperature can be made at this menu. Settings
for the min/max values and the sensor configuration are available at this parameter.
All sensors contain of an in-plant balance.
•
Alarm/Messages
Alarms and messages can be adjusted at this menu. This alarms and messages report when
the temperature falls below an adjusted value or exceed an adjusted value.
•
Controller general
At this menu, the desired function (heating, cooling or heating & cooling) can be assigned
and general settings, like setpoints, can be adjusted.
•
Controller settings
This menu appears as soon as the controller has got a function assigned. Integrated
controllers can be chosen at this menu and the chosen controller can be parameterized
further.
The temperature sensor SCN-TS1UP.01 only has "Setup general", "Temperature measurement" and
"Alarm/Messages".

2.6 Commissioning

After wiring the allocation of the physical address and the parameterization of every channel follow:
(1) Connect the interface with the bus, e.g. MDT USB interface
(2) Switch-on bus voltage
(3) Press the programming button at the device (red programming LED lights)
(4) Loading of the physical address out of the ETS-Software by using the interface (red LED turns
off as soon as the process is successfully completed)
(5) Loading of the application, with requested configuration
(6) If the device is enabled, you can test the requested functions (also possible by using the ETS-
Software)
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Germany
6
Phone: +49-2263-880 • knx@mdt.de • www.mdt.de
[SCN-RT1xPx.01]