Adjusting The Rear Shield; Mounting The Counter Weights - Toro Reelmaster 5510 Series Operator's Manual

1. Cutting unit kickstand
3

Adjusting the Rear Shield

No Parts Required
Procedure
Under most conditions, the cutting unit produces
best dispersion when you close the rear shield (front
discharge). When conditions are heavy or wet, you
may open the rear shield.
To open the rear shield
screw securing the shield to the left side plate, rotate
the shield to the open position and tighten the cap
screw.
Figure 3
(Figure 4), loosen the cap
g003318
1. Rear shield
4
Mounting the Counter
Weights
No Parts Required
Procedure
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
counter weights and reel motors.
1. On the #2 and #4 cutting units, remove the 2
cap screws securing the counter weight to the
left end of the cutting unit.
2. Remove the counter weight
6
Figure 4
2. Cap screw
Figure 5
(Figure 6).
g003316
g003319