Table Of Contents; Safety - Toro Reelmaster 5510 Series Operator's Manual

Contents
Safety ....................................................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 5
1 Inspecting the Cutting Unit ............................... 5
2 Using the Cutting Unit Kickstand ...................... 5
3 Adjusting the Rear Shield................................. 6
4 Mounting the Counter Weights......................... 6
Product Overview ..................................................... 7
Specifications .................................................... 7
Cutting Unit Accessories and Kits ....................... 7
Operation .................................................................. 8
Adjustments........................................................ 8
Turf Compensation Settings ..............................11
Height-of-Cut .....................................................11
Servicing the Bedknife ...................................... 16
Maintenance ........................................................... 18
Lubricating the Cutting Unit............................... 18
Adjusting the Reel Bearings.............................. 18
Servicing the Bedbar ........................................ 19
Servicing the HD Dual Point Adjusters
(DPA) ............................................................ 20
Servicing the Roller........................................... 21

Safety

This machine has been designed in accordance with
EN ISO 5395:2013.
To control hazards and prevent accidents, it
is essential that those who operate, transport,
maintain, and store the machine be aware,
concerned, and properly trained. Improperly
using the machine can result in injury or death. To
reduce the potential for injury or death, comply
with the following safety instructions.
•
Read, understand, and follow all instructions in the
traction unit and the cutting unit Operator's Manual
before operating the cutting unit.
•
Never allow children to operate the traction unit
or cutting units. Do not allow adults to operate
traction unit or cutting units without proper
instruction. Only trained operators who have read
this manual should operate the traction unit or
cutting units.
•
Never operate the cutting units when under the
influence of drugs or alcohol.
•
Keep all shields and safety devices in place.
If a shield, safety device or decal is illegible or
damaged, repair or replace it before operating the
cutting unit. Also, tighten any loose nuts, bolts,
and screws to ensure that the cutting unit is in safe
operating condition.
•
Always wear substantial, slip-resistant shoes.
Do not operate the cutting units while wearing
sandals, tennis shoes, or sneakers. Also, do not
wear loose fitting clothing which could get caught
in moving parts. Always wear long pants, safety
glasses, and safety shoes.
•
Remove all debris or other objects that might
be picked up and thrown by the cutting unit
reel blades. Keep all bystanders away from the
working area.
•
If the cutting blades strike a solid object or the unit
vibrates abnormally, shut off the cutting units, park
on a flat surface, set the parking brake, shut off
the engine, and remove the key. Check the cutting
unit for damaged parts. Repair any damage before
starting and operating the cutting unit.
•
Lower the cutting units to the ground, and remove
key from ignition switch whenever you leave the
machine unattended.
•
Ensure that the cutting units are in safe operating
condition by keeping nuts, bolts, and screws tight.
•
Remove the key from the ignition switch to prevent
the engine from accidently starting when servicing,
adjusting, or storing the machine.
•
Perform only those maintenance instructions
described in this manual. For major repairs or
assistance, contact an authorized Toro distributor.
3