Reset To Default Settings; Calibration Of Touchpanel - TESTO Sensor LD basic Instruction Manual

Leak detector
Table of Contents

Advertisement

11.3.3.2

Reset to default settings

Settings ➔ System ➔ Reset to Defaults

11.3.4 Calibration of touchpanel

Settings ➔ calibrate touchscreen
Testo Sensor LD basic V1.00 EN
Bevor the settings are changed to the
production default settings a safety prompt
is displayed and must be confirmed by
pressing the button „Yes".
If needed with „Reboot System" the Testo
Sensor LD basic could be started(reboot)
here.
If necessary, the touch-screen calibration
can be changed here.
Push
Calibrate
and it appears, 1. left
above,2. bottom right, 3. bottom left, 4.right
above and 5. in the middle, a calibration
cross that must be pushed consecutively.
If the calibration finished positive a message
"Calibration successful"
be confirmed with OK.
Is this not the case, so you can repeat the
calibration with the help of the
Calibrate
button.
Operation
appears and have to
Cancel
and
Seite 15 von 22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sensor LD basic and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents