Lexmark 6200 Series Quick Start Manual

Safety Information
• Use only the power supply provided
with this product or the manufacturer's
authorized replacement power supply.
• Connect the power supply cord to an
electrical outlet that is near the product
and easily accessible.
• Refer service or repairs, other than
those described in the user
documentation, to a professional
service person.
CAUTION: Do not use the fax feature
during a lightning storm. Do not set up this
product or make any electrical or cabling
connections, such as the power supply
cord or telephone, during a lightning
storm.
3

Load paper

1 2
Lift the paper support and Load plain paper.
extend the paper exit tray.
5

Install the print cartridges

2 Open the cartridge lids, insert the cartridges, and
1
Lift the scanner unit.
snap the lids closed.
6200 Series All-In-One
1
Unpack your All-In-One
Note: Contents may vary.
3
Lower the paper feed guard,
squeeze the paper guide, and
slide it to the left edge of the paper.
3
2
Left: Right:
1 2 3
2
Prepare your All-In-One
1
Connect the power cord.
4
Prepare the print cartridges
1 Remove the photo
cartridge from the
print cartridge storage
unit.
1
3 Close the scanner unit. 4 Press Select to print an
alignment page.
1
3
2
You may discard the
alignment page after it
prints.
Lexmark Confidential until announced
2 3
Make sure the
Power light is
on.
2
1
2 Remove the sticker and tape from the print cartridges.
1
2
Warning: Do not touch the copper contact area on
the back or the metal print cartridge nozzles on the
bottom.
Cartridge storage
1
Keep a new or
partially used
cartridge in the
print cartridge
storage unit:
If you are using your
All-In-One with a computer,
continue with "Install the
software"...
*21B0070*
Press the right arrow button
to scroll to your language,
and then press Select
.
2
1
1
2
2 Place the stored cartridge
in the storage area of your
All-In-One.