Table of Contents
Advertisement
Available languages
Available languages
● Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding the
work by hand or against your body leaves it unstable and
may lead to loss of control.
Residual risks
The following risks are inherent to the use of saws:
● Injuries caused by touching the rotating parts.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These are:
● Impairment of hearing.
● Risk of accidents caused by the uncovered parts of the
rotating saw blade.
● Risk of injury when changing the blade.
● Risk of squeezing fingers when opening the guards.
● Health hazards caused by breathing dust developed when
sawing wood, especially oak, beech and MDF.
Safety of others
● This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the tool by a person responsible for
their safety.
● Children should be supervised to ensure that they do not
play with the appliance.
Labels on tool
The following symbols are shown on the tool along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
● Never attempt to open for any reason.
● Do not expose the battery to water.
● Do not store in locations where the temperature may
exceed 40 °C.
● Charge only at ambient temperatures between 10 °C and
40 °C.
● Charge only using the charger provided with the tool.
● When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
(Original instructions)
Chargers
● Use your charger only to charge the battery in the tool with
which it was supplied. Other batteries could burst, causing
personal injury and damage.
● Never attempt to charge non-rechargeable batteries.
● Have defective cords replaced immediately.
● Do not expose the charger to water.
● Do not open the charger.
$
● Do not probe the charger.
The charger is intended for indoor use only.
#
Electrical safety
This charger is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
● If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service Centre in
order to avoid a hazard.
@
Description (Fig. A)
WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
1. On/off switch
2. Lock off button
3. Main handle
4. Secondary handle
5. Shoe
6. Saw blade
7. Lower blade guard
8. Lower guard retracting lever
9. Bevel adjustment lever
10. Bevel angle scale
11. Outer blade clamp washer
12. Blade retaining bolt
13. Depth adjustment lever
14. Spindle lock button
15. Battery
16. Battery release button
17. Hex wrench
@
18. Dust extraction port
WARNING: Do not cut any metals, masonry, glass,
tile or plastic with this saw. A dull blade will cause
slow, inefficient cutting overload on the saw motor,
excessive splintering, and could increase the
possibility of kickback.
● DO NOT use any abrasive wheels.
@
● Use only blades designed for wood cutting.
WARNING: Cutting sap coated wood, and other
materials may cause melted substances to
accumulate on the blade tips and the body of the saw
ENGLISH
27
Advertisement
Table of Contents
