Solve Setup Problems - Lexmark 3200 MFP User Manual

Solve setup problems

Problem
Ready message not displayed
Control panel buttons not responding
Scanner is not working
Test document did not print
Unable to send or receive faxes
Network scanning modes
(SCAN PROFILE, SCAN
or SCAN FTP) do not appear in the
control panel
Getting more help
Solution
The control panel and the printer are not talking to each other, or the
printer or scanner may be turned off.
1 Turn the printer off, and then back on.
2 Turn the printer and scanner off. Make sure all cables and cords are
connected, and then power up in the correct order.
Note: Remember to turn the scanner on before turning on the printer.
Make sure the printer is turned on.
Note: Remember to turn the scanner on before turning on the printer.
1 Make sure the scanner is unlocked. See step 5 on page 23.
2 Turn printer and scanner off. Make sure all cables and cords are
connected, and then power up in the correct order.
Note: Remember to turn the scanner on before turning on the printer.
1 Verify that each electrical outlet has power.
2 Make sure all cables and line cords are properly seated.
3 Restart the copy job.
1 Make sure the telephone fax line cable is properly connected to the
fax modem port on the print server and to the fax phone outlet.
2 Repeat the fax setup. See "Set send and receive fax information" on
page 32.
3 Refer to the online information on the MFP CD. Click View
Documentation
Scan to network modes must be configured in order to show up in the
EMAIL, MFP control panel. See "Set up network scanning" on page 37 for
detailed instructions.
Launch the MFP CD, and then click Contact Lexmark for a complete
list of phone numbers and Web sites.
Solve setup problems
Use MFP
42
Solving fax problems.