Lexmark 3200 Getting Started Manual

Color jetprinter
Hide thumbs Also See for 3200:

Advertisement

Getting Started

Advertisement

Table of Contents
loading

Summary of Contents for Lexmark 3200

  • Page 1 Getting Started...
  • Page 2: Unpack Your Printer

    User’s guide Setup software Use a parallel cable that supports bidirectional communication (IEEE 1284-compatible), such as Lexmark P/N 1329605. Fasten the metal clips on the Power supply printer to the parallel cable. Getting started Remove all of the packing material from the printer.
  • Page 3: Plug In Your Printer

    Plug in your printer 2b... to the computer Connect both ends of the power supply Connect the parallel cable to the computer. Make sure you tighten the screws. Connect the power supply to the printer. Plug the power supply into an electrical outlet.
  • Page 4: Install The Print Cartridges

    Install the print cartridges Is the power light on? Raise the front cover Power light Cartridge carrier If the power light is on, continue with step 4. When you raise the front cover, the cartridge carrier moves to the loading position. If not, check your connections.
  • Page 5 Unpack the cartridges Insert the cartridges Black Color Tape DO NOT touch the copper Sticker contact area Remove each new print cartridge from its packaging. Remove the sticker and the transparent tape covering the copper area on the cartridges.
  • Page 6 Snap the cartridges into Close the front cover place SNAP SNAP Push back on the cartridges until they snap securely into place. If the print cartridges move loosely in the carrier, they are not locked into place. Repeat this step.
  • Page 7: Load Paper

    Load paper Prepare for loading Place up to 100 sheets of plain paper in the sheet feeder Paper support Media guide Insert the paper against the right side of the sheet feeder. Slide the media guide to the edge of the paper. Exit tray...
  • Page 8: Install The Printer Software

    Ask our Technical Support Center to mail you diskettes. Refer to the printer registration card for the number in your country. Refer to the Lexmark 3200 User’s Guide for information on how to install the printer software from diskettes. •...
  • Page 9 Hours of Operation: 9 AM-9 PM Monday through Friday and 12 PM-6PM Saturday and Sunday (Eastern Time). Or you may contact Lexmark at: http://www.lexmark.com Please have the following information available so we may serve you faster. (Located on the back of the printer)

Table of Contents