Step 9: Set Send And Receive Fax Information - Lexmark 3200 MFP User Manual

Step 9: Set send and receive fax
Understanding
FCC fax
requirements
Note:
See "Electronic
Emission notices" on
page 48 and
"Telecommunications
notices" on page 48 for
more FCC information.
Note:
If you do not have a
TCP/IP environment, you
must use the MFP control
panel to set your basic fax
information.
information
During fax setup, you must assign some basic information. The
Telephone Consumer Protection Act of 1991 requires all outgoing
faxes to contain the following information in a margin at the top or
bottom of each transmitted page, or on the first page of the
transmission:
• Date and time (date and time fax is sent)
•
Station name (identification of the business, other entity, or
individual sending the message)
• Station number (telephone number of the sending fax machine,
business, other entity, or individual)
There are three methods to enter your fax setup information. They are
1) manually entering the information through the MFP control panel,
2) using your browser to access the MFP IP address and then
entering the Configure menu, or 3) using MarkVision Professional to
access the MFP IP address and enter the Configure menu.
Use the following table to find the instructions for the method you
want to use.
Method
Performing manual fax setup
Performing browser fax setup
Using MarkVision Professional to set fax information
Set send and receive fax information
32
Page
33
34
35