Wali GPV002 Installation Manual

INSTALLATION MANUAL
Monitor Desk Stand
GPV002
Supplied Parts List
Base Left Arm
B(x1) C(x1)
Pole
Allen Key 4mm Allen Key 6mm
A(x1)
J(x1) K(x1)
1
Connect Pole A and Base B using Bolt F and tighten A B F
with Allen Key 4mm J . J
A
B
F
J
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
75x75\100x100
Right Arm VESA Plate Bolt
D(x1) E(x2) F(x6)
M4x12 Bolt M4x16 Bolt M5x12 Bolt
M-A(x8) M-B(x8) M-C(x8)
2
Tear off the protective paper to attach Anti-Skid Pad I to
the bottom designated position of Base B as image shown.
B
I
B
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
(6kg/13.2lbs)x2
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Bolt Nut Anti-skid Pad
G(x2) H(x2) I(x1)
M5x16 Bolt D5 Washer Spacer
M-D(x8) M-E(x8) M-F(x8)
3
I Connect both Left Arm C and Right Arm D with Pole A C
using Bolt F , tighten with Allen Key 4mm J . F
D
C
A
F
J
4
Step 4.1
Select TV Screws
M4 M5
Step 4.3a
D A
Flat Back Monitor
J
Select M4x12 Bolt M-A or M5x12 Bolt
VESA Plate E together with D5 Washer
TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
M-E
M-C
Step 4.3b
Curved Back Monitor
Select M4x16 Bolt M-B or M5x16 Bolt
VESA Plate E together with D5 Washer
holes on the back of TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
M-E
M-B
M-D
M-F
Step 4.2
Select Spacers ( if needed )
M-C according to your TV/Monitor, connect
M-E into the mounting holes on the back of
M-E
E
M-A
M-D according to your TV/Monitor, connect
M-E and Spacer M-F into the mounting
E