Related Manuals for Wali GSDM002-P
Summary of Contents for Wali GSDM002-P
- Page 1 Dual Monitor Desk Mount 32" GSDM002-P 75x75/100x100 (2-12kg)x2 (4.4-26.4lbs)x2 RATED support@walielectric.com...
- Page 3 Supplied Parts List VESA Plate Pole Base A (x1) B (x2) C (x1) D (x1) C-Clamp Cover Bolt C-clamp Brace F (x1) G (x1) H (x1) E (x1) Spring Washer Support Plate Grommet Base Plate L(x1) J (x1) K (x1) I (x1) M6X16 Bolt M6X12 Bolt...
- Page 4 Step 1 Fit clamp: 0.4”-3.3” Grommet: 0.4”-3.3“ Step 2 Option A Clamp Installation Connect Pole and Base from the bottom using Bolt M6X16 Bolt and tighten with 4mm Allen Key R. 2.Connect Base D and C-clamp Brace using M6X12 Bolt N and tighten with 4mm Allen Key .
- Page 5 3.Select the preferred height firstly and connect C-Clamp to C-Clamp Brace using M6x10 Bolt and tighten with 4mm Allen Key 0.4”-2.2” 2”-3.3” 4.Rotate the hand knob clockwise to fasten for stability. Attach the Cover G to the C-clamp.
- Page 6 Option B Grommet Base Installation 2. Tear off the protective paper to attach Anti-Skid Pad P to 1.Guide Grommet Base Plate through Bolt the bottom designated position of Base as image shown. connect them to Base from the bottom using M6x12 Bolt and tighten with 4mm Allen Key 3a.
- Page 7 4.Insert the assembled Pole through the desk hole, guide the Support Plate , Washer and Nut through the Bolt H , rotate the Nut clockwise to fasten for stability. Step 3...
- Page 8 Step 4 Step 4.1 Step 4.2 Select Monitor Screws Only one screw size fits your Monitor Hand thread screws into the threaded inserts on the back of your Monitor to determine which screw diameter (M4 or M5) to use. Step 4.2 Select M4x12 Bolt or M5x12 Bolt according...
- Page 9 Step 6 To properly balance the arm with monitors mounted, adjust the spring tension with 6mm Allen Key First, position and firmly hold the arm horizontally as shown. Ask for assistance should you require it. If the arm drops, turn the adjustment screw counter-clockwise until it stays in a horizontal position.
- Page 10 Step 7 Guide the cable through the cable slot.
- Page 11 Step 8 Angle Adjustments Tilt: Adjust the VESA Plate tilt using 6mm Allen Key S . (Tilt +45°/-45°) Note: Adjust to the desired angle then tighten the screws using the Allen key as shown, alternating from each screw as you tighten them.
- Page 12 We support the technology that brings your home to life. We offer high quality products, professional customer service, and extensive technical support. If you have any questions,please contact us. support@walielectric.com 1-844-SATTLER (18447288537) www.walielectric.com...