Care And Cleaning - Electrolux ESF 2200 DW User Manual

Programme
3)
Rinse & Hold
1) This is the standard washing programme for test institutes. Refer to the supplied leaflet for test information.
2) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
3) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad
odours to come out from the appliance.
Do not use detergent with this programme.

CARE AND CLEANING

TO REMOVE AND CLEAN THE FILTERS
Dirty filters decrease the washing results.
Although the maintenance is very low with
these filters, make a check at intervals and
if necessary, clean them.
1. Turn the fine filter (B) counterclockwise
and remove it out from the main filter
(A).
A
2. To remove the coarse filter (C), hold
tightly the fine filter (B) and press the
two sides of the coarse filter (C).
3. Pull the coarse filter (C) out of the fine fil-
ter (B).
C
B
Type of soil Programme descrip-
Type of load
Cold prewash
B
Duration
tion (min)
14
4. Fully wash the two filters with water and
a brush.
5. Remove the main filter (A) and fully wash
it with water.
6. Put the main filter (A) in its initial posi-
tion. Make sure that it assembles cor-
rectly.
7. Put the fine coarse filter (C) in the fine fil-
ter (B). Make sure that they assemble
correctly in each other.
8. Put the fine filter (B) in the main filter (A)
and turn it clockwise until it locks.
TO CLEAN THE SPRAY ARMS
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
TO CLEAN THE EXTERNAL SURFACES
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (e.g. acetone).
electrolux 11
Ener- Water
gy (l)
(kWh)
0.01 2.1