Rear Panel - Omnitronic MA Series User Manual

Rear panel

16
17
Nr. Element
Mains fuse
16
Mains cable
17
18 SPEAKER OUTPUT terminals
Line output
19
LINE 4 input
20
LINE 3 input
21
22 MIC 3/LINE 2 input
23 MIC 2/LINE 1 input
24 DIP switches
25 MIC 1 input
18
Funktion
Only replace the fuse when the unit is disconnected from the mains. Only
use a fuse of the same rating and power. The correct fuse value is specified
on the rear panel.
For connection to a mains outlet.
• 70V/100V: for connecting 70 V and 100 V speakers
• 4Ω/8Ω/16Ω: for connecting 4-16 Ω speakers
• COM: common ground connection for all speakers
Stereo RCA output for connection to units with line level inputs (e.g. mixer,
amplifier).
Stereo RCA inputs for connecting units with line level (e.g. CD player).
Stereo RCA inputs for connecting units with line level (e.g. CD player).
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
• 1 and 2: line level (upper position) or microphone level (lower position) at
inputs MIC 3/LINE 2 or MIC 2/LINE 1
• 3: phantom power on (upper position) or off (lower position) at input MIC 1
• 4: priority circuit on (upper position) or off (lower position) at input MIC 1
Balanced XLR jack for connecting a microphone. For a phantom-powered
microphone set DIP switch 3 to the upper position. To enable the priority
circuit for this input, set DIP switch 4 to the upper position. Then the level of
the other inputs is attenuated when an announcement is made via this input.
21 • EN
19 20 21 22 23 24
25