Rear Panel - Omnitronic CPZ-60 User Manual

Rear Panel

19
22
No. Element
19 AC POWER switch
20 CH1-4 / COM terminals
21 Antenna connection
22 Power input with fuse holder
23 SPEAKER OUTPUT terminals
24 DC24V IN terminals
25 LINE output
26 LINE 4 input
27 LINE 3 input
28 MIC 3/LINE 2 input
29 MIC 2/LINE 1 input
30 CONTROL DIP switches
31 MIC 1 input
20
23 24 25
Function
Turns the AC power unit on and off, which suppresses any interference
noise in emergency power operation.
Terminals for zones 1 to 4 for connecting 70 V / 100 V speakers and
common ground connection. Always use the protective cover during
operation to avoid short-circuits.
Connection for the included cable areal or your analog cable connection.
When using the cable areal, uncoil its entire length and place it e.g. along
the wall.
Used to plug in the supplied power cable. Only use fuses of the same rating
and power. The correct fuse value is specified on the rear panel. Only
replace the fuse when the unit is disconnected from the mains.
• 70V/100V: for connecting 70 V and 100 V speakers
• 4Ω/8Ω/16Ω: for connecting 4-16 Ω speakers
• COM: common ground connection for all speakers
Always use the protective cover during operation to avoid short-circuits.
Screw terminals for a 24 V emergency power. Always use the protective
cover during operation to avoid short-circuits.
RCA jacks for the mixed signal to connect, e.g. an additional amplifier.
RCA jacks for connecting audio units with line level (e.g. CD player).
RCA jacks for connecting audio units with line level (e.g. CD player)
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
• 1 and 2: line level (upper position) or microphone level (lower position) at
inputs MIC 3/LINE 2 or MIC 2/LINE 1
• 3: phantom power on (upper position) or off (lower position) at input MIC 1
• 4: priority circuit on (upper position) or off (lower position) at input MIC 1
Balanced XLR jack for connecting a microphone. For a phantom-powered
microphone set DIP switch 3 to the upper position. To enable the priority
circuit for this input, set DIP switch 4 to the upper position. Then the level of
the other inputs is attenuated when an announcement is made via this input.
21 • EN
26 27 28 29
21
30 31