AXIOMTEK CEM700 Quick Installation Manual

Quick Start
The basic procedures required to power on CEM700:
(1). Make sure the power is OFF before connecting the CEM700.
(2). Check to ensure the onboard switch SW1-1 and SW1-2 are set to
default (OFF position).
(3). Firmly install DDR4 SO-DIMM in DIMM1/DIMM2 until fully seated. For
single memory channel configuration, install memory module in
channel 0 (DIMM2) DDR4 SO-DIMM socket. For dual memory
channel configuration, install memory modules of the same size, chip
width, density and rank in both channel 0 (DIMM2) and channel 1
(DIMM1) DDR4 SO-DIMM sockets.
(4). Attach heatsink to the CEM700, refer to section Installing Thermal
Solution.
(5). Install the CEM700 onto COM Express
CEB94701 baseboard.
(6). Properly install all necessary peripheral devices such as hard disk,
display, keyboard and etc. to the baseboard.
(7). Firmly attach power supply to the baseboard power connector.
(8). Turn on the system power.
(9). Press power button on the baseboard to start CEM700.
4
TM
baseboard, for example,
9418D700000E
©
Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in Taiwan
CEM700 Quick Installation Guide
Checklist
CEM700 Board x1
Quick Installation Guide x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Please refer to the product information DVD for the complete user's
manual, drivers and utilities. User's manual and related documents are
in Acrobat PDF format.
Module Layout
Top View
9418D700000E
©
Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in Taiwan
Product Information DVD x1
1