Warranty - Ego Power+ CS1610E Manual

◾
PROBLEM CAUSE
◾
◾
◾
Chain saw does
not cut properly.
◾
◾
◾
Chain becomes
◾
loose or drops off
the guide bar
during normal use.

WARRANTY

EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
Insufficient chain tension.
Dull chain.
Chain installed backwards.
Worn chain.
Dry or excessively stretched
chain.
Chain not in bar groove.
The chain will become loose
as the temperature of the
chain increases
normal saw operation.
Chain does not engage drive
sprocket.
CORDLESS CHAIN SAW — CS1610E
◾
SOLUTION
Readjust the chain tension,
following the section:
◾
"ADJUSTING THE CHAIN
◾
TENSION".
Sharpen the chain.
Reinstall the saw chain, following
the section
◾
"ASSEMBLING/REPLACING
THE BAR AND CHAIN".
Replace the chain, following the
section:
◾
"ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Check the oil level. Refill the oil
tank if necessary.
Reinstall the saw chain, following
the section:
◾
"ASSEMBLING/REPLACING
THE BAR AND CHAIN".
Tighten the chain tension,
following the section
◾
during "ADJUSTING THE CHAIN
TENSION"
Reinstall the saw chain, following
the section:
"ASSEMBLING/REPLACING
THE BAR AND CHAIN".
EN
24