Warranty - Ego Power+ CS2000E Original Instructions Manual

PROBLEM CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Chain saw does not cut
Worn chain.
properly.
◾
Dry or excessively stretched chain.
◾
Chain not in bar groove.
◾
The chain will become loose as the
temperature of the chain increases
Chain becomes loose or
during normal saw operation.
drops off the guide bar
◾
Chain does not engage drive sprocket.
during normal use.

WARRANTY

EGO WARRANTY POLICY
Please visit the website egopowerplus.eu egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS2000E
SOLUTION
◾
Readjust the chain tension, following
the section: "ADJUSTING THE CHAIN
TENSION".
◾
Sharpen the chain.
◾
Reinstall the saw chain, following the
section "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Replace the chain, following the section:
"ASSEMBLING/REPLACING THE BAR
ANDCHAIN".
◾
Check the oil level. Refill the oil tank
and choose a higher oil supply volume if
necessary.
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
◾
Tighten the chain tension, following
the section "ADJUSTING THE CHAIN
TENSION".
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING THE
BAR AND CHAIN".
EN
15