(cont'd)
KEYSTROKE
1. Enter Offset:
1 7
2. Enter the advance:
2 (Advance)
3. Enter the Roll and calculate the pipe
length and unknown bend angle:
6 1 2
(Roll)
Continue pressing the
related values.
Rolling Offset – Cut Length
Find the end-to-end pipe length for a rolling
pipe offset with a 13" Roll, a 24" Offset,
and an advance of 32". The bend angle is
unknown. This example assumes 6" Steel,
factory made long radius butt weld elbows
are used with a Welder's Gap of 3/32" (the
default is 1/8").
Note: All Take-Out calculations are based
on Carbon Steel O.D. See the Cut Length
– Known Take-Out Value example to solve
Cut Lengths for known Take-Out values.
KEYSTROKE
DISPLAY
OFST 17 INCH
RUN 28 INCH
LNTH 33-3/8 INCH
FIT° 33.02°
key to view all
DISPLAY
ALL CLEArEd
KEYSTROKE
1. Enter Pipe Size:
6
2. Change the default Welder's Gap from
1/8" to 3/32":
*
2
3. Enter Offset:
2 4
4. Enter the advance:
2 (Advance)
5. Enter the Roll and calculate the pipe
length and unknown bend angle:
1
(Roll)
*Setting welder's gap to 3/32 inch will
temporarily set the outputs to 1/32 fractional
resolution. To keep outputs in their current
P
R
ocket
efeRence
DISPLAY
STD SIZE 6 INCH
GAP 0-3/32 INCH
OFST 24 INCH
RUN 32 INCH
LNTH 42-1/16 INCH
CUT 35-1/4 INCH
TO 3-5/16 INCH
GAP 0-3/32 INCH
FIT° 40.46°
IARC 4-1/32 INCH
CARC 6-11/32 INCH
OARC 8-11/16 INCH
(cont'd)
G
— 29
uide