Shark DuoClean NZ801UK Series Quick Start Manual

MAINTENANCE
Empty dust cup after each use
Release
Empty
Access brushroll and Soft Roller
1. Use a coin to unlock the 3 locks on the
bottom of the floor nozzle, a portion of
the base is removable to allow for better
access to the brush roll and exposure to
the airway. Shine a torch from the bottom
to check for possible blockage in the
airway.
2. Clear away any objects or debris.
3. To reassemble, replace base by
lining it up along the front of the
nozzle. Push down to snap into
place. Lock the 3 locks.
For questions or to register your product, contact us at
0800 862 0453 or visit us online at sharkclean.eu
@sharkcleaninguk
©2019 SharkNinja Operating LLC. All rights reserved.
Made in China. SHARK and DUOCLEAN are registered trademarks of SharkNinja Operating LLC.
LIFT-AWAY and POWERED LIFT-AWAYare trademarks of SharkNinja Operating LLC.
TIP:
Wash filters to keep the
suction strong.
Rinse filters and allow to air-dry
completely. Tap loose dirt
from foam filters as needed
between washes.
See enclosed instructions for
complete details on removing
and cleaning filters.
Brushroll Maintenance
Carefully remove any debris that may be
impeding the brushroll.
Soft Roller Maintenance
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the
airway, then remove any blockages.
@sharkcleanuk
@sharkcleanuk
NZ801UK_Series_QSG_REV_190709_Mv1
Please be sure to read the enclosed Shark instructions prior to using your vacuum
DUOCLEAN
®
POWERED LIFT-AWAY™ WITH
ANTI HAIR WRAP TECHNOLOGY
QUICK
START
GUIDE
Use this Quick Start Guide
to start using your new
vacuum's great features.
Register your vacuum at
registeryourshark.com
NZ801UK SERIES