Installing A Retainer Bracket; Installing A New Drive - Lenovo ThinkCentre M58p 3063 Hardware Installation And Replacement Manual

6. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
Figure 13. Installing a retainer bracket
7. For a 3.5-inch drive, you must use a Universal Adapter Bracket, 5.25 to
3.5-inch. You can obtain a Universal Adapter Bracket, 5.25 to 3.5-inch from a
local computer retailer or by contacting the Customer Support Center. Install a
retainer bracket on the side of the Universal Adapter Bracket.
8. Install the 5.25-inch drive or the adapter bracket and 3.5-inch drive into the
bay.
Figure 14. Installing a new drive
9. To reinstall the bezel, align the plastic tabs on the right side of the bezel with
the corresponding holes in the chassis, then pivot the bezel inward until it
snaps into position on the left side.
10. Continue at "Connecting a serial ATA drive."
Connecting a serial ATA drive
A serial optical drive or an additional hard disk drive can be connected to any
available SATA connector.
1. Locate the signal cable that comes with the new drive.
2. Locate an available SATA connector on the system board. See "Identifying parts
on the system board" on page 9.
3. Connect one end of the signal cable to the drive and the other to an available
SATA connector on the system board.
Chapter 3. Installing options and replacing hardware
21