Replacing The Primary Hard Disk Drive; Replacing The Heat Sink And Fan Assembly - Lenovo ThinkCentre M58p 3063 Hardware Installation And Replacement Manual

7. Position the new heat sink and fan assembly on the plastic retention bracket so
Figure 20. Replacing the heat sink and fan assembly
8. Connect the heat sink and fan assembly cable to the microprocessor fan
9. Go to Chapter 4, "Completing the parts replacement," on page 47.

Replacing the primary hard disk drive

This section provides instructions on how to replace the primary hard disk drive.
To replace the primary hard disk drive:
26
Hardware Installation and Replacement Guide
that the four screws are aligned with the posts on the system board. Tighten
the four screws 1 to secure the heat sink and fan assembly to the system
board.
connector on the system board.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that came with your computer.
To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Important
When you receive a new hard disk drive, you also receive a set of Product
Recovery discs. The set of Product Recovery discs will enable you to restore the
contents of the hard disk drive to the same state as when your computer was
originally shipped from the factory. For more information on recovering
factory-installed software, refer to "Recovering software" in your ThinkCentre
User Guide.
1. Remove the computer cover. See "Removing the cover" on page 11.
2. Locate the primary hard disk drive. See "Drive specifications" on page 18.
3. Disconnect the signal and power cables from the hard disk drive.