Installing The Primary Hard Disk Drive And Bracket - Lenovo ThinkCentre M58p 3063 Hardware Installation And Replacement Manual

10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the hard disk drive cage into the chassis.
11. Connect the signal and power cables to the rear of the new hard disk drive.
12. Press down on the metal latch 2 , pivot the drive cage into place, and then
slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in the
proper position.
Figure 23. Installing the primary hard disk drive and bracket
13. Go to Chapter 4, "Completing the parts replacement," on page 47.
Chapter 3. Installing options and replacing hardware
29