Connecting Drives; Installing A Retainer Bracket; Installing A New Drive - Lenovo J200 Hardware Installation And Replacement Manual

7. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
Figure 15. Installing a retainer bracket
8. For a 3.5-inch drive, you must use a Universal Adapter Bracket, 5.25 to
3.5-inch. You can obtain a Universal Adapter Bracket, 5.25 to 3.5-inch from a
local computer retailer or by contacting the Customer Support Center. Install a
retainer bracket on the side of the Universal adapter bracket.
9. Install the 5.25-inch drive or the adapter bracket and 3.5-inch drive into the
bay.
Figure 16. Installing a new drive
10. To reinstall the bezel, align the plastic tabs on the right side of the bezel with
the corresponding holes in the chassis, then pivot it inward until the three
plastic tabs snap into position on the left side.
11. Continue at "Connecting drives."

Connecting drives

The steps to connect a drive are different depending on the type of drive. Use one
of the following procedures for your drive connection.
Connecting the first optical drive
1. The drive requires two cables; a power cable that connects to the power supply
and a signal cable that connects to the system board.
2. Locate the three-connector signal cable that comes with your computer or with
the new drive.
Chapter 3. Installing options and replacing hardware
23