Troubleshooting; Xvs-9000/Xvs-8000/Xvs-7000/Xvs-6000 Does Not Start Normally - Sony XVS-9000-C Service Manual

3-1.

XVS-9000/XVS-8000/XVS-7000/XVS-6000 Does Not Start Normally

XVS-9000/XVS-8000/XVS-7000/
XVS-6000 does not start normally.
Is indication of the Status LED
on the front board changing?
YES
Is the monitor screen output
correctly?
YES
Detailed check is required.
Inform the service personnel of
the symptom of the fault.
• Status LED
The Status LED value of each board represents the board startup status.
(For the Status LED position on each board, refer to "1-8. Description of On-board Switches and LEDs" in the
Installation Manual.)
If the Status LED value is fixed, carry out troubleshooting according to the board status.
Status LED
LED 1 LED 0
CA-92 Board
Status Status Status
dis- dis-
play play
LED1 LED0
8. 8. Waiting for board
startup
0 5 Waiting for DHCP
acquisition
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
Section 3

Troubleshooting

NO
Take appropriate actions
according to the Status LED
indication. (Refer to the table below.)
NO
The rear board may be faulty.
Check that the connection
is correct.
Possible cause
Failure of the board
The network is not operating
correctly.
PWS-110SC1 is not running.
Recovery means
Replace the board.
Re-check the network connection and settings.
Start the PWS-110SC1.
Continued
3-1