Mercedes-Benz E-Class Coupe 2017 Owner's Manual page 336

Aluminium hub cap
To remove: position socket
#
1.
% The socket can be found in the tyre-change
tool kit.
Position wheel spanner 3
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
To fit: position hub cap 1
#
completely flush with the wheel.
Position socket 2 on hub cap 1.
#
Attach wheel spanner
#
tighten the hub cap clockwise.
Specified tightening torque: 25 Nm.
Raise the vehicle (
#
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle is prepared for a wheel change
R
( page 332).
→
2 on hub cap
The hub caps have been removed
R
( page 332).
→
Important notes on using the jack:
Only use the vehicle-specific jack that has
R
on socket 2.
been tested and approved by Mercedes-Benz
to raise the vehicle.
1
The jack is only designed for raising and
R
holding the vehicle for a short time while a
and turn until it is
wheel is being changed and not for mainte‐
nance work under the vehicle.
3 to socket 2 and
page 333).
→
Wheels and tyres 333
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large,
load-bearing, non-slip underlay.
The base of the jack must be positioned ver‐
R
tically under the jack support point.
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the
R
vehicle.
Do not lie under the vehicle.
R
Do not start the engine and do not release
R
the electric parking brake.
Do not open or close any doors or the boot
R
lid.