Mercedes-Benz E-Class Coupe 2017 Owner's Manual page 335

Table of Contents

Advertisement

332 Wheels and tyres
Centring pin
R
Folding wheel chock
R
Ratchet for jack
R
Setting up the folding wheel chock
Preparing the vehicle for a wheel change
Requirements:
The required tyre-change tool kit is available.
R
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Vehicles with manual transmission:
#
Engage first or reverse gear.
Vehicles with automatic transmission:
#
Shift into position j.
Vehicles with AIR BODY CONTROL: Set the
#
normal vehicle level (
page 188).
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
Remove the hub caps if necessary
#
(
page 332).
Raise the vehicle (
page 333).
#
Removing and fitting hub caps
Requirement:
The vehicle is prepared for a wheel change
R
(
page 332).
Plastic hub cap
To remove: turn the centre cover of the hub
#
cap anti-clockwise and remove the hub cap.
To fit: make sure that the centre cover of the
#
hub cap is turned anti-clockwise.
Position the hub cap and turn the centre
#
cover clockwise until the hub cap engages
physically and audibly.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E seriesE 300E 400 4matic

Table of Contents