Charge Level Displays; Inserting And Removing The Memory Card - Leica X1 Instructions Manual

To remove the battery, follow these instructions in reverse order. The light
grey sprung locking catch at the battery compartment must be pushed
aside to unlock the battery.
Note:
Removing the battery while the camera is switched on (see p. 88) can re-
sult in the settings you made in the menus being erased (see p. 89) and
the card being damaged.

Charge level displays

The charge level of the battery is displayed on the monitor (see p. 76, 2.1.5).
Notes:
• Remove the battery, if you will not be using the camera for a long period
of time. When doing so, turn the camera off using the main switch (1.7,
see p. 88) first.
• The date and time must be reset after approx. 3 days at the latest after
the capacity of a battery in the camera has expired (see p. 84).

Inserting and removing the memory card

The LEICA X1 takes SD or SDHC memory cards. These cards have a write-
protection switch that can be used to prevent unintentional storage and
deletion of pictures. This switch takes the form of a slider on the non-beveled
side of the card; in the lower position, marked LOCK, the data on the card
is protected.
Note:
Do not touch the memory card contacts.
1. Set the main switch (1.7) to
2. Open the the battery/memory card compartment door (1.30) by turning
the locking lever (1.30a) clockwise. The spring-loaded door then opens
automatically.
3. Insert the memory card (B) into the slot (1.35) with the contacts facing
the battery. Push it in against the spring resistance until you hear it click
into place.
4. Close the battery/memory card compartment door and turn the locking
lever anti-/clockwise.
86
OFF
.